Deskworks can integrate with an HID Card Scanner for manual checkin at a front desk or door. People can scan in and will be logged in as present. When they leave, they can log out. Their usage will be tracked against their plan.
Open a ticket to let us know you would like this integration activated. Once the integration is set up, follow these steps on your Wedge:
1. (Example 1) Go to your wedge URL on the tablet, probably 192.168.63.99. Click GENERAL OVERVIEW on the top menu bar. Be sure your firmware version is greater than 02.xx.xxx (ours is 04.00.000f.)
2. (Example 2) Click Keyboard Wedge tab on the top menu bar
a. Click General Config tab
1. Check Keyboard Wedge Enable
2. Check Boot Interface
b. (Example 3/4) Click Card Data Selection tab
1. Select Card Type: FSK Prox (e.g. HID Prox…)
2. Enter Prestroke: PACS:
3. Enter Poststroke: [ENTER]
3. (Example 5) Click System Config on the top menu bar
a. Click APPLY CHANGES
b. Click STORE CHANGES
c. Click REBOOT SYSTEM
Wait for the page to reload. It will take at least 30 seconds and may take longer.
Was this article helpful?
That’s Great!
Thank you for your feedback
Sorry! We couldn't be helpful
Thank you for your feedback
Feedback sent
We appreciate your effort and will try to fix the article